[sebhc] Z37 Calibration

[Peter Shkabara]

There was also an article in REMark (as I recall) that showed how to modify
the H37 controller to read 8-inch disks. This would in effect make the
modified H37 equivalent to a CDR controller.

Peter
-----------------------------------------------------------
peter59 at sbcglobal.net - http://www.geocities.com/anapro.geo/
 

> -----Original Message-----
> If you have a 1.44meg 3.5" or 1.2meg 5.25" drive that is NOT 
> switchable,
> the only way to use it with the H89 is with a Magnolia or CDR 
> controller
> board, configured to treat these as if they were 8" 1.2meg drives.
> -- 
> Lee A. Hart  814 8th Ave N  Sartell MN 56377  
> leeahart_at_earthlink.net

--
Delivered by the SEBHC Mailing List