[sebhc] Z37 Calibration

[Mark Garlanger]

The two 5.25" drives are Full-Height Tandom TM100-4, these should be 96 tpi
drives.  The 3.5" drive is 720k. I got both 5.25"'s and the 3.5" from ebay.

			Mark

> -----Original Message-----
> From: sebhc-bounces at sebhc.org [mailto:sebhc-bounces at sebhc.org] On Behalf
> Of Dwight K. Elvey
> Sent: Thursday, March 31, 2005 11:34 AM
> To: sebhc at sebhc.org
> Subject: RE: [sebhc] Z37 Calibration
> 
> >From: "Mark Garlanger" <garlangr at verizon.net>
> ---snip---
> 
> >
> >When I was formatting disks, it sounded like it was working, but after
> about
> >30 seconds, it came back with an "Unable to format this disk" error
> message.
> >I'm using drives I had not tested before so I don't know if it is the
> >controller or the drives, but I did try two different 5.25" drives and
> one
> >3.5" drive and got the same message. I guess I'll wait for the Z37 diag
> disk
> >and see if it can narrow down the problem.
> >
> 
> Hi
>  You need to use a 360K drive. I suspect that the 5.25
> you have is a 1.2M and it won't work with the 3.5. These
> are 1.44M.
> Dwight
> 
> 
> --
> Delivered by the SEBHC Mailing List

--
Delivered by the SEBHC Mailing List